Serving New Braunfels and Comal and Guadalupe County since 2003
Licensed & InsuredFree EstimatesMon-Fri 7am-5pm
(830) 221-9409 Licensed & Insured
Book a Free Foundation Inspection
Commercial Foundation Repair in New Braunfels, TX

Commercial Foundation Repair in New Braunfels, TX

New Braunfels Superior Foundation Repair offers professional commercial foundation repair in New Braunfels, TX with 23 years of piering slabs under heavy loads. We repair foundations under retail buildings, restaurants, offices, medical clinics, churches, schools and warehouses using drilled bell-bottom piers, steel push piers, helical piers and pressed concrete pilings. Commercial work is quoted per project after an independent engineer reviews the plan.

Commercial foundation repair runs on engineering, schedules and paperwork. We work from sealed engineering where the job calls for it, pull the permit, and stage the excavation around your business hours. Every pier we install carries a lifetime warranty that transfers with the building.

Get a FREE Estimate

Or call (830) 221-9409

  • Work staged around business hours and tenant schedules
  • Pier logs and drive pressures for your engineer and insurer
  • General liability of $1 million per occurrence, $2 million aggregate
  • Lifetime transferable warranty on every pier

Commercial Foundation Repair by Property Type

Retail Strip Centers

Retail Strip Centers

Entry slabs at storefronts tend to crack first, and the beam drops away from the canopy columns. We pier along the front beam in sections, barricade the walk and keep at least one entry open for every tenant while the work goes on.

Restaurants

Restaurants

Restaurants carry heavy kitchen equipment, grease traps and a lot of drain line under the slab. We coordinate the plumbing tests with your plumber and schedule interior work for the days you're closed.

Offices and Medical Clinics

Offices and Medical Clinics

Sloped floors in a clinic cause trip hazards and doors that won't close on their own. We stage interior breakouts room by room so you can keep seeing patients while the work moves through the building.

Churches and Fellowship Halls

Churches and Fellowship Halls

Older sanctuaries and halls are often pier and beam with long spans between supports. We replace pads and set steel shims under the girders, and we schedule around services and events.

Schools and Daycares

Schools and Daycares

Most of the work happens over summer or school breaks. Excavations get fenced at the end of every day, and we coordinate access and parking with your facilities staff before we mobilize.

Warehouses and Light Industrial

Warehouses and Light Industrial

Settlement at dock walls and column footings is common on slab-on-grade buildings. We drill bell-bottom piers or drive steel push piers under the point loads the engineer identifies, and log every one.

Signs of Commercial Foundation Problems

Commercial buildings show movement the same way houses do, just on a bigger scale. Storefront doors that drag or won't lock, cracks running up from the corners of display windows, and gaps opening where a canopy meets the building are the common ones.

Inside, look for tile cracking in a line across a sales floor, ceiling grid going out of square, and office or exam room doors that swing open or shut on their own. In a warehouse, watch the dock walls and the slab joints near the column lines.

When to Call the Engineer First

If you see cracks wide enough to slip a coin into, a column that's visibly out of plumb, or a wall pulling away from the roof, call a structural engineer before you call us. We'll work from their findings and bring our readings to the same meeting.

Commercial Foundation Repair Methods

Commercial loads are heavier and more concentrated, so pier choice matters more. Drilled bell-bottom piers, with 12-inch shafts and 24 to 30-inch bells in 3,000 PSI concrete, handle heavy column and wall loads. They cure 7 days before the structure goes back on them.

Steel push piers give your engineer a recorded drive pressure on every pier, which is what a lot of commercial specs ask for. Helical piers fit canopies, light structures and spots where a push pier can't get enough reaction weight. Pressed concrete pilings still work well under single-story commercial slabs with moderate loads.

Inside the building, we can break out the slab in small sections or tunnel in from outside, the same way we do on homes. On a sales floor or in a clinic, tunneling usually wins because it keeps the floor open.

Working Around a Business That Stays Open

Your business stays open. We plan the excavation in sections, barricade every open hole, keep entries and parking usable and haul spoil off site at the end of each day.

Interior work gets scheduled for closed hours where we can arrange it, with dust control and floor protection. Crews work 7am to 5pm on weekdays, and we'll start at 7 sharp so the noisy work is done before you open.

If you lease, we coordinate with your landlord or property manager too. Most commercial leases put the structure on the owner, so the estimate, the schedule and the engineer's letter usually need to reach them as well.

Engineering, Permits, Paperwork and Pricing

Commercial jobs start with engineering. We work from an independent engineer's design, or your own engineer's, and pull the city permit before we mobilize.

At closeout you get a pier map, pier logs with depths and pressures, photos, plumbing test results and the engineer's letter. Certificates of insurance showing general liability at $1 million per occurrence and $2 million aggregate, plus workers' comp, go out before we start.

Many commercial properties also have an insurer or lender asking questions. The pier logs and the engineer's letter answer most of them, and we're glad to walk an adjuster through the readings on site.

How Commercial Foundation Repair Is Priced

Commercial work is quoted per project after engineering, because pier counts and loads vary too much for a rule of thumb. Mobilization is priced as its own line, so you can compare bids side by side.

Apartment and multi-family buildings are priced per building, typically $9,500 to $38,000 each, because that work runs closer to residential slab repair than to a warehouse job.

The inspection and readings are free, the same as on a house. Engineering is paid direct to the engineer, so the letter in your file stays independent of our bid.

Talk to Us About Your Property

Call (830) 221-9409 or send the form. We'll walk the building, review any engineering you have and give you a written scope and price.